The large size of the LCD splicing screen is not fixed, it can choose the corresponding size according to its actual needs.

1. Installation method of LCD splicing screen

1. There are many requirements for LCD splicing screens, and the ground must be flat, because the entire system of LCD splicing screens has its own requirements in terms of volume and weight.

2. Because of its installation location, you need to consider its bearing weight. If the floor is tile, you may not be able to bear its weight. You must estimate its weight in advance.

3. Install on the ground and have anti-static treatment. This measure must be done well. Otherwise, there will be leakage problems and easy to hurt people. You still have to take a sense of responsibility.

4. First go to the installation site to investigate, plan the installation location and determine the corresponding plan, and then start to pay attention to the light environment and wiring problems. If you handle it well, you can increase its viewing effect.

5 When the LCD splicing screen, first assemble the splicing screen according to the prompts, and then use the screws to install its fixing frame on the splicing screen. The movement must be fixed on the fixed movement frame, and then the selected Install and fix at the installation location.

6. In the wiring process, you must pay attention to the installation of control equipment, and also pay attention to the ventilation of the LCD splicing screen installation location, because the temperature may rise when it is running, which facilitates heat dissipation.

2. Analysis of precautions for LCD splicing screen installation

1. Wiring requirements

(1) When installing the LCD splicing screen, the wiring should be distinguished between the power line and the signal line, and install them in different places to avoid interference and increase the trouble of work.

(2) Then, according to the screen size and installation position of the entire project, calculate the length and specifications of the various lines needed, and then estimate the materials for the entire project, which can be prepared in advance.

2. Ambient light

(1) The brightness of the LCD splicing screen requires very high light, but the use is limited. The light around the installation environment should be selected, not too strong or too weak, otherwise the picture on the screen may not be seen.

(2) The light that may enter near the screen should be shielded. When the device is running, the light should be turned off to ensure the normal operation of the device.

3. Framework requirements

(1) In order to increase the maintenance of the LCD splicing screen, the frame hemming must be a detachable hemming. The inner edge of the outer frame must be left with a gap of about 25mm from the outer edge of the splicing wall. Large splicing walls should appropriately increase the spacing according to the number of columns.

(2) In the later stage of the cabinet maintenance, the maintenance channel should not be less than 1.2m wide in principle; the detachable side strip should be pressed against the edge of the screen by 3-5mm. It is best to fix it after the cabinet and the screen are installed in place. Removable side strips.